AT-Pro pinpointing off-center

[log2lumber]

My AT-Pro is pinpointing off center. Mostly to the left and up with the 8.5x11 coil. Hunting playgrounds and fields without a coil cover. I even cleaned the coil, unplugged everything and did a reset. This started a couple of months ago. Any ideas?

 

Amazon Forum Fav 👍

Upgraded Night Vision Monocular Digital Infrared Monocular Telescope for 100% Darkness with 8X Zoom - Grab it through Amazon!

[sprailroad]

Pin pointing with my AT is iffy at best, alittle better with the smaller coil, but with the stock coil, mine seems more to the rear. I have a minelab Safari that is dead on, the AT?, more of a challenge.

 

[mindcrime1988]

Did the pinpointing just start to be off or has it always been this way since new? There are a several tricks in learning how to pinpoint with the AT Pro which I can share but if you're detector just started pinpointing off center and it is not new, you may want to contact Garrett for assistance.

 

[log2lumber]

It is not new. It has done this once before and a factory reset work. I have had it for 3 or 4 years.

 

[sprailroad]

Did the pinpointing just start to be off or has it always been this way since new? There are a several tricks in learning how to pinpoint with the AT Pro which I can share but if you're detector just started pinpointing off center and it is not new, you may want to contact Garrett for assistance.

For me, I think it's always been this way. Could be I'm spoiled with the Safari, in that the "pinpoint" is very sharp in tone, or response, and the AT will increase then decrease in tone as you pass back & forth, not a big problem, just different machines.