Connecting headphone cable to clip on AT Pro

[Sandscoopdan]

Hi, any of u guys know how to attach the headphone cable to the headphone clip under the arm cuff. The cable keeps sliding back out. It doesn't stay

 

Amazon Forum Fav 👍

Minelab PRO-FIND 35 Waterproof Pinpointer Metal Detector for Experts with Tone ID & Adjustable Sensitivity - Grab it through Amazon!

[wvwildman]

i had to bend mine to keep it from slipping out

 

[Sandscoopdan]

Thank u wvwildman

 

[wvwildman]

your very welcome Happy Hunting

 

[Sapper724]

There's a clip?!

 

[wvwildman]

yep right under the arm rest where the screw is

 

[Sapper724]

Lol, now I have to run out to the car to find it!

 

[Sandscoopdan]

Lol

 

[Sapper724]

Yeah, I'm an idiot sometimes... Lol, OK most of the time

 

[extreme detecting]

Just wrap some tape around the headphone cable where it gets "snapped" into the clip leaving about 1" overlap on either side of the cable. This will create a tight fit and prevent the cable from wearing at that point.

Funny - for the new Gray Ghost Amphibian we designed...we specifically made sure the cable had enough straight length so you could snap it into that clip PLUS we added a shrink wrap over the cable at that exact spot where it gets clipped to do just what I mentioned above. We tried to address every item on this design...

 

[rks1949]

I wish Garrett would come out with a extension that fit under the cuff adding length to the head phone cord. It would also be great if it had the "water proof" connections on both ends. I had my cable ran in the clip,but due to the short length of the head phone cable (stock one's) I didn't like it,and now just run it out to the side under the control box.

 

[cooper1841]

Theres a clip? I have been fightin that damn cord since I got it Thanks guys That's a lot better