Kosh
Jr. Member
- Joined
- Dec 4, 2011
- Messages
- 28
- Reaction score
- 4
- Golden Thread
- 0
- Location
- Saratoga Springs, New York
- Detector(s) used
- Garrett GTP 1350
- Primary Interest:
- All Treasure Hunting
Hi all, I just got a GTP 1350 and was wondering if there is some advice or special settings anyone could share.
I tested it out today at a local park. I took about 10 steps and found a dime right off the bat. It said it was a dime and low and behold it was, 3 inches down. Now I did however (of course) have many bottle caps and pull tabs show up as coinage on the first pass. The signal jumped around a bit and as I am still learning the machine I dug the signals. I had it set on the "ZERO" setting as I wanted to get used to it.
Any advise would be welcome.
Thanking you in advance
KOSH
I tested it out today at a local park. I took about 10 steps and found a dime right off the bat. It said it was a dime and low and behold it was, 3 inches down. Now I did however (of course) have many bottle caps and pull tabs show up as coinage on the first pass. The signal jumped around a bit and as I am still learning the machine I dug the signals. I had it set on the "ZERO" setting as I wanted to get used to it.
Any advise would be welcome.
Thanking you in advance
KOSH
Amazon Forum Fav 👍
Upvote
0