Etrac Procoil

Dr.Jones

Full Member
Joined
Aug 19, 2005
Messages
130
Reaction score
90
Golden Thread
0
Location
Kennett square , PA
Detector(s) used
Minelab E-Trac
Last year I bought a coiltek 6" treasureseeker. I love it and have some good finds with it. Yesterday I put back the original coil and it is going haywire. It starts jumping all over the place whether it's on the ground or in the air. I noise cancel and it doesn't help. Any ideas?? I'm at a loss
 
Upvote 0
I noticed my stock coil very sensitive after I replaced my 6 inch coil tech coil also. I suspect I tweaked it a tad too much. Usually what your describing is a coil issue. I would save your prigrams and do a factory reset. See if that helps. Im wondering if we both just have bad stock coils. What are the odds.
 
Was your coil bad? I feel like it would do it with the small coil of it was anything else. I'm annoyed but now it gives me a reason to get a new bigger coil
 

Users who are viewing this thread

Back
Top Bottom