Etrac setting w/o the BS talk

[Woodland Detectors]

POST ONLY YOUR SETTINGS! IF YOU HAVE COMMENTS OR QUESTIONS PM THE MEMBER PLEASE




4-h--- I myself am finding out that I keep going back to the stock settings with some personal adjustments. Lately, In NC I use Relic mode. Combined with a simple nail reject option. (fields of RW-CW buttons etc) Manual sensitivity bumped up to 26. Rec deep--off--rec fast---off---conduct---2 tones. High gain--threshold pitch high- It's working lately
----------------------------------------------------------------------------------------------------------------------------------------------------
--Another member Treasure net suggests--
Default Coins Program for me.
Trash Density - High
Ground - Difficult
Gain - 24
Deep - ON
Fast - OFF
Everything else is stock.
At this point it's a turn on and two step and go...

Step one - noise cancel (sensitivity should be at least 20 when doing this)
Step two - Tweak Sensitivity as you hunt - Manual 20-25 (Found out Auto +3 is lacking depth on main coil and Sunray Probe)
(optionally, noise cancel again if you are nutty about it - I'm not)

Keep coil low and slow.

Switch to quickmask with FE25 to investigate iffy signals.

I hunt mainly midwest USA parks. Posted by Treasure net member

 

Amazon Forum Fav 👍

Diving for Pleasure and Treasure - Grab it through Amazon!

[Woodland Detectors]

TMAN-------------------------------------------------------


I run the stock coin program. Sens +2, ground neutral, deep off, fast on, gain is around 26. I am going to check the auto sens at +2 then after getting some idea of the ground condition, I will go to manual and bump it up 3 more and check some targets. TMAN.

 

[Woodland Detectors]

the first two outings were run in the stock coins program,did very well. I then set up the Deep Coin Settings for an Explorer SE with changes to the E=trac from Andy Sabish's book. Using Normal Response,Threshold barely audible,Recovery deep on,recovery fast off, Sensitivity 20. I tweeked that from man to auto to see what it was doing and found in Manual that it seemed to do a little better in the heavy trash. This area is hit by many and has been over the years

 

[Woodland Detectors]

----------RONC-----------


Heres how I run mine and since Sept I have found over 100 silver coins
coin mode with the little bar top right edited out
auto+3
deep on
theshold level 18

volume limit 30
gain 21
response pitch hold
trash low
threshold pitch 15
ground difficult
pinpiont sizing
I switch back and forth to quickmask often to check iffy deep targets also I lower my sens when I have higher sens mosty in my area my sens runs 19-20 with a +3 in Auto
HH RonC

 

[Woodland Detectors]

Hi all
I have been trying something new that seems to work great
I run in auto +3 in coin mode and on my quick mask I have been running wide open
this is great when using the sunray probe more depth and the ability to find them pesky nails and see and hear the iffy target a little better HH RonC

 

[goldeagle]

what sunray probe is recom?

 

[Cuerno]

There is only one Sunray probe for the E-Trac (X-1 Probe)... Here are my setting
1. Noise cancel first
2. Threshold level just barely audible
3. Volume limit 30
4. Volume gain 22
5. Response normal
6. Threshold pitch 30
7. Tone ID = No. of tones---Multi /Sounds---conduct/Variability---29/limits---29
8. Recovery deep off
9. Recovery fast off
10. Trash density high
11. Ground difficult