duggr
Sr. Member
- May 4, 2006
- 303
- 154
- Detector(s) used
- Minelab CTX 3030
- Primary Interest:
- All Treasure Hunting
I have a couple of set's of Headphones I put together. One is Made from a Moldex Muff and the other from
from an H.L. V-3 muff. Both are "NEW" and are built with premium parts, Neutrik connector's Military grade
Microphone Cord that will stretch to 7-8'. Each is housed with two 2" (50mm) 100-ohm Mylar drivers for a wide
range full sound and wired with Low Z microphone cable. The Moldex has right and left volume controls with sealed
pot's and a Mono/Stereo switch for compatibility with most detectors. The V-2 muff has the same features and components
as the Moldex but I have added another toggle switch for the Minelab CTX metal detector. Both $ 110.00 each shipped lower 48.
"Note"
If your looking for lightweight set get the V=3's
Looking for outside noise reduction get the Moldex
from an H.L. V-3 muff. Both are "NEW" and are built with premium parts, Neutrik connector's Military grade
Microphone Cord that will stretch to 7-8'. Each is housed with two 2" (50mm) 100-ohm Mylar drivers for a wide
range full sound and wired with Low Z microphone cable. The Moldex has right and left volume controls with sealed
pot's and a Mono/Stereo switch for compatibility with most detectors. The V-2 muff has the same features and components
as the Moldex but I have added another toggle switch for the Minelab CTX metal detector. Both $ 110.00 each shipped lower 48.
"Note"
If your looking for lightweight set get the V=3's
Looking for outside noise reduction get the Moldex
