Minelab and Coil Cable Dry Rot

Thead

Jr. Member
Joined
Jul 16, 2005
Messages
59
Reaction score
15
Golden Thread
0
Location
Florida
Detector(s) used
TDI Pro, Surf PI Pro, BeachHunter ID, Sovereign GT and Excalibur 1000 (my favorite)
Primary Interest:
Beach & Shallow Water Hunting
I was recently bitten by the infamous coil cable "dry-rot" issue on my Excalibur 1000 as the family was packing to head to one of our favorite beach vacation sites. Much to my surprise, when I checked some of my spare coils (mainly for my Sovereigns), I found that they too were starting to suffer from the same issue. I knew this was eventually going to happen based on all of the posts on this subject that I have seen but it is still frustrating when it actually hits you. What is even more frustrating is that I have a two Whites water detectors that are older than all of my Minelab detectors and the Whites detectors are still doing just fine. I hope that Minelab is doing something to address this issue so that future Excalibur/Sovereign/XXXXX models do not cause their owners the same problem. JVF - just venting folks.
 

Top Member Reactions

Users who are viewing this thread

Back
Top Bottom