Need info on using Etrac to find wellhead

[Gunny71]

This coming Friday I will need to use my Etrac to try and locate a plugged oil well. It should be a piece of 8 5/8 pipe with a flat plate or cap welded on it, and will be approximately three feet deep. Does anyone know if the Etrac will be able to locate this?
Thank in advance.

 

Amazon Forum Fav 👍

How to Research for Treasure Hunting and Metal Detecting From Lead Generation to Vetting - Grab it through Amazon!

[Charlie P. (NY)]

Can't help you with that model, but in general: zero discrimination/All Metal mode. Start with the sensitivity low so every nail and rusty metal chip doesn't block you. Start in the corner of the house nearest the water tank (obviously).

After you find it write it's location in pencil on the wall behind the tank for the next poor shmoe.

My brother-in-law was trying to find his and had spent a day digging with no success. He called and I traveled to his house with my detector to help. He had a huge hole where he thought it was and had piled all the dirt off where he knew the well head was not. I searched where he suggested, then fanned out. Found lots of things, including a three foot claw foot pry bar, but no well head.

And, of course, it turned out to be smack under the center of the huge pile of dirt where he "knew it could not be".

 

[Gunny71]

Thanks, I'm just gonna have to try it. This is an oil well though, out in the middle of a pasture. I should be able to get close to where it's at.

 

[G.A.P.metal]

Gunny
If that Etrac has a relic mode i would use that.I would think that a top of the line detector would pick up a metal plate 8" wide at 3'.
Gary