Ohms Plummet to .5 - 5

[NinjaT]

Yesterday I was using a two probe resistivity system to check a 85 ft hole some people had been digging in an area of the Philippines which beyond 1-2 ft depth is pure limestone from calcified coral reef. With the hole positioned in the center of our probes, from the surface down to about 90 ft we were getting readings which increased from around 130 steadily on up to around 300 ohms as we increased the spacing of the probes. Then at about 200 ft probe spacing there was a huge drop in resistivity. From a reading of 300-330 ohms on the previous reading with about 180 ft spacing, it dropped to .5 ohms and maintained for almost a full minute leveling out at a peak of 5 ohms. This was inland enough to not be saline ground water and too high to be freshwater which would have given a much higher reading at this depth anyways.

What on this good earth could possibly have caused such a massive drop in resistivity beyond a stack of gold bars? Can anyone with experience using geo resistivity meters weigh in?

We were using a pro machine, $20,000 mining equipment.

Iris Instruments T-VLF

 

Amazon Forum Fav 👍

How to Research for Treasure Hunting and Metal Detecting From Lead Generation to Vetting - Grab it through Amazon!

[Al D]

Yesterday I was using a two probe resistivity system to check a 85 ft hole some people had been digging in an area of the Philippines which beyond 1-2 ft depth is pure limestone from calcified coral reef. With the hole positioned in the center of our probes, from the surface down to about 90 ft we were getting readings which increased from around 130 steadily on up to around 300 ohms as we increased the spacing of the probes. Then at about 200 ft probe spacing there was a huge drop in resistivity. From a reading of 300-330 ohms on the previous reading with about 180 ft spacing, it dropped to .5 ohms and maintained for almost a full minute leveling out at a peak of 5 ohms. This was inland enough to not be saline ground water and too high to be freshwater which would have given a much higher readig at this depth anyways.

What on this good earth could possibly have caused such a massive drop in resistivity beyond a stack of gold bars? Can anyone with experience using geo resistivity meters weigh in?

We were using a pro machine, $20,000 mining equipment.

Iris Instruments T-VLF

Buried wreckage from WW2 perhaps?

 

[NinjaT]

Buried wreckage from WW2 perhaps?

The reading was taken at a probe spacing of 200 ft so the anomaly was somewhere around 100 ft depth under pure limestone. To reach the current depth of the hole they had to use a jackhammer to dig straight through the limestone which was pure calcified coral all the way down to the current depth of 85 ft. This is in an area where a lot of tunneling had taken place by the Japanese when depositing treasure during WW2. So someone would have had to dig a hole straight through limestone down to 100 ft and then tunnel over to bury the wreckage or anything else.

 

[BC1969]

A tunnel and shaft like that would be no problem for humans.
Look at the Pyramids.
Best of luck finding treasure!