Question for SE users

[DANGLANGLEY]

I just bought an SE and I got several high pitched signals that showed up as fer-31 con-31. I got several more close to that and had the same numbers on both sides. I was concentrating on low ferrous and high conductivity coin range signals just to get a feel for the machine so I didn't dig them up. What do you think a fer-31 con-31 signal might be? Any other advice will be greatly appreciated, even if you think it's elementary. Thanks for your time.

DANGLANGLEY

 

Amazon Forum Fav 👍

Family Maps of Hinds County, Mississippi, Deluxe Edition - Grab it through Amazon!

[Brett]

31:31 is almost always iron... but if it's bouncing from that corner to the upper right corner, then it could be a deep coin next to some iron. I would also mask off the 4 pixels that form a square in the upper right hand corner. Sometimes nails bounce into that conductive region, which is typically never associated with a coin.

 

[DANGLANGLEY]

31:31 is almost always iron... but if it's bouncing from that corner to the upper right corner, then it could be a deep coin next to some iron. I would also mask off the 4 pixels that form a square in the upper right hand corner. Sometimes nails bounce into that conductive region, which is typically never associated with a coin.

Thanks for your help. Every tidbit I can get will help so much.

DANGLANGLEY

 

[edgemano]

I run my se in ferrous mod. so i can here the high and low tones iron and coins. good luck i have found alot of good targets mixed with iron in this set up.