Gypsy Heart
Gold Member
- #1
Thread Owner
In the hayday of copper mining in the Keweenaw, copper was mined from the rocks with the use of stamp mills. The stamp mills would crush the brittle rock leaving the copper behind. The trailings (or stamp sands) left over from the mining were just dumped into the lake. As stamping technologies improved, these trailings could be further stamped to yield more copper. In 1913, the Calumet and Hecla Mining Company built the C&H Dredge number one. This was later sold to the Quincy Mining Company in 1951, and became known as the Quincy Dredge Number 2.
A few years after Quincy bought the dredge, their first dredge, Quincy Dredge Number 1 sunk in a storm. Dredge Number 2 was used until 1967. The Quincy Dredge Number 2 sits about 4/10 of a mile north of Mason on M-26 on the Keweenaw Peninsula, right across the street from the Quincy Mill. The dredge is half sunken in the water, and can be clearly viewed from the road. It is possible to enter the dredge too, but it is not recommended due to the excessive decay from sitting half sunked in the water for years. There are also legal issues, but there are not any "No Trespassing" signs to be seen in the vicinity
The quincy Mill is accross from Quincy Dredge Number 2 on M-26 in Houghton County, Michigan. Stay tuned for more details in the future.
A few years after Quincy bought the dredge, their first dredge, Quincy Dredge Number 1 sunk in a storm. Dredge Number 2 was used until 1967. The Quincy Dredge Number 2 sits about 4/10 of a mile north of Mason on M-26 on the Keweenaw Peninsula, right across the street from the Quincy Mill. The dredge is half sunken in the water, and can be clearly viewed from the road. It is possible to enter the dredge too, but it is not recommended due to the excessive decay from sitting half sunked in the water for years. There are also legal issues, but there are not any "No Trespassing" signs to be seen in the vicinity
The quincy Mill is accross from Quincy Dredge Number 2 on M-26 in Houghton County, Michigan. Stay tuned for more details in the future.