Sand scoop help

robbor

Full Member
Joined
Aug 20, 2005
Messages
151
Reaction score
24
Golden Thread
0
Location
Nevada
Detector(s) used
XLT, GM3, GM4b
Upvote 0
Zele makes some good scoops. I like the Stealth by Sunspot Products in Michigan. It works fine in all bottom types and has a long floating wood handle that takes lots of hard use without harm. Extremely strong stainless steel.

http://www.sunspotedm.com/beachscoops/

HH,
Sandman
 

Attachments

  • STEALTH SCOOP.webp
    STEALTH SCOOP.webp
    13.8 KB · Views: 542
  • STEALTH SCOOP.webp
    STEALTH SCOOP.webp
    13.8 KB · Views: 334
  • STEALTH SCOOP.webp
    STEALTH SCOOP.webp
    13.8 KB · Views: 364
  • STEALTH SCOOP.webp
    STEALTH SCOOP.webp
    13.8 KB · Views: 379
If money is tight then build my scoop for ten dollars. Go to a feed store and buy a galvanized grain scoop, go to hardware and buy a 8 foot section of EMT (electrical metal tube). Have hardware store bend the tube into the shape of a U. Buy some stainless steel 1 1/4" bolts and two 2" bolts with locknuts plus washers. Take a 3/8" drill bit and drill sifting holes in the scoop but don't drill the back until the handle is installed. Drill out the rivets on the scoop handle and enlrge holes to 1/4". Lay handle alongside EMT and match its length plus one inch. Mash that last inch flat then bend it down at a right angle. At the other mark, beat it flat and bend it to match the area where the grain scoop handle was. Take a scrap piece of EMT, from the other end, to use as a cross beam as the grain scoop was. You'll want to measure the other end so it lines up with the bottom and then hacksaw off the excess. Drill your holes to assemble everything. Drill your 3/8" holes on scoop back.
This scoop lasted me about 8 years until I found enough to buy a $200 scoop.
Good luck.

Harry
 

Harry,

I would sure like to see a picture of your homemade scoop. Can you post one? It sounds interesting.

Ed Donovan
 

Top Member Reactions

Users who are viewing this thread

Back
Top Bottom