Sunray X-1 Probe...HELP!

[mustang8780]

Dont know where to post this so here goes....

I have an X-1 target probe on my Minelab E-trac. It has worked great for the few months or so but all of a sudden it has started to go haywire. I lose my threshold whenever I am trying to pin point and touch the pinpointer… if that doesn’t make sense let me explain further.

When I locate a target with my detector and dig a plug I flip the switch to probe. I have my threshold tone until I actually touch the probe itself…no matter where I touch it…the cable or anywhere along its length. It also falses like crazy a high pitch when i try and move it in the hole (not always though) but I never really get my threshhold hum...even if I hold it straight out in the air. When there is a target directly under the probe it does locate it but not like its supposed to do…or like it did up until this weekend...

 

Amazon Forum Fav 👍

How to Research for Treasure Hunting and Metal Detecting From Lead Generation to Vetting - Grab it through Amazon!

[Woodland Detectors]

Send it back.

Sounds faulty to me buddy.

Call them @


Phone:

1-319-636-2244

Fax

1-319-636-2258

Sun Ray office hours are:

9 am - 5 pm Mon - Fri CST

Sun Ray Detector Electronics
106 N Main St
PO Box 300
Hazleton, Iowa 50641-0300

 

[mustang8780]

Thanks Mike...again.

From reading some other post it may be my sensitivity is runnning too high...I will check that first tonight.

Phil