ColonelDan
Bronze Member
- Joined
- Jan 19, 2014
- Messages
- 1,008
- Reaction score
- 2,188
- Golden Thread
- 1
- Location
- Central Florida
- 🥇 Banner finds
- 1
- 🏆 Honorable Mentions:
- 1
- Detector(s) used
- Deus II
- Primary Interest:
- Beach & Shallow Water Hunting
- #1
Thread Owner
I was hunting at the beach yesterday and did my usual "dial it in" routine...adjusting F2, Recovery and Sensitivity using my test sticks to optimize my EQX 800 performance for that particular beach.
As I hunted, I got a strong tone of a high conductor and started to dig and dig and dig. I couldn't see or find the target but I knew it was still there...somewhere...the EQX said it was!
I finally narrowed it down to a certain pile of sand from the ever growing hole. Still couldn't see it but it was there among the brown sand...somewhere. Finally resorted to my Pro-Find 35 pinpointer. It rang up nicely but I still couldn't see this high conductor! I started to test small hand fulls at a time and finally...finally I saw a minuscule piece of wire on the edge of my hand. Could this be what all the fuss was about? YES. I measured the depth of the hole with the Pro- Find 35 and saw that it was approximately 8 inches!
I brought the wire home specifically to post this story about the importance of adjusting your detector to meet the conditions. When we change beaches, I "dialed in" my EQX again for that new beach and had to change the settings from that first beach where my EQX sniffed out that piece of wire. Conditions change and so must your settings....one size DOES NOT FIT ALL.

As I hunted, I got a strong tone of a high conductor and started to dig and dig and dig. I couldn't see or find the target but I knew it was still there...somewhere...the EQX said it was!
I finally narrowed it down to a certain pile of sand from the ever growing hole. Still couldn't see it but it was there among the brown sand...somewhere. Finally resorted to my Pro-Find 35 pinpointer. It rang up nicely but I still couldn't see this high conductor! I started to test small hand fulls at a time and finally...finally I saw a minuscule piece of wire on the edge of my hand. Could this be what all the fuss was about? YES. I measured the depth of the hole with the Pro- Find 35 and saw that it was approximately 8 inches!
I brought the wire home specifically to post this story about the importance of adjusting your detector to meet the conditions. When we change beaches, I "dialed in" my EQX again for that new beach and had to change the settings from that first beach where my EQX sniffed out that piece of wire. Conditions change and so must your settings....one size DOES NOT FIT ALL.

Last edited: