What's new

Anderson coil weight for BHID/Dual Field PI

Slimpickins

Full Member
Joined
Feb 16, 2014
Messages
223
Reaction score
258
Golden Thread
0
Detector(s) used
Equinox 800, Whites Dual Field PI
Primary Interest:
All Treasure Hunting
I have no luck looking for reviews of this product. If it does make a huge difference at keeping the coil in the zone without trying to float off the bottom, i might look into getting one.
 
Upvote 0
Try a stainless steel bolt that will just fit inside the lower shaft, cut off the head and slide it into the shaft.
This has been working fine for me for many years and a bit less expensive.
 
I had one and put it on and went to the beach. Tried it out for about 2hrs and I just didn’t like balance of it. It was very heavy, especially in current. Made coil control a little more difficult to me. So, it definitely kept the coil from floating, kept it on the bottom so I had to pull up in the strong current. However, I really liked using the PI Dual Field without the weight. I also had the blue anderson shaft on it. I found that set up very easy to move across the bottom. All I had to do was keep a slight bit of pressure - pushing down but not too much pressure and I got it to glide across fast moving currents. I may have to get another one soon. I like the way that surf master looks with that purple looking coil. Pi dual field is so smooth sounding in waist deep water, isn’t it? I got to where I was just digging the whisper signals and it was always a good target that I scooped up
 

Users who are viewing this thread

Back
Top Bottom