Fisher F22 falsing help

[Kentucky Digger]

I took my fisher F22 out today and decided to hit up a creek. After I was done detecting the creek I went back to dry land and the F22 started falsing immediately. I turned down the sensitivity to 6 (I run it on 7) and still falsing. 5 sensitivity was the highest I could keep it without it going insane.

I put the sensitivity on 6 and 7 and waved in in the air near no metal. It still beeped like it had locked onto a great signal. The VDI number was all over the place as well.

Any help about what to do would be great.

 

Amazon Forum Fav 👍

Family Maps of Hinds County, Mississippi, Deluxe Edition - Grab it through Amazon!

[G.A.P.metal]

Sounds like you might have a small leak in the coil or the wire near the coil.
Wait a couple of days put it in a dry place see if it will dry out ...or put another coil on and see if that helps .
Gary

 

[fjs440]

Try a reset (reboot) by turning on the detector and keep holding down the powerbutton for around ten seconds.

Also make sure the cable is on really tight. That fitting always seemed to be coming loose on my F2. Just a very little tightening with a pliers. Do not crank it hard.

Those two things used to clear all my problems with the F2.

A water leak in the coil sounds like a very strong possibility.

------------------------------
Fisher F70 w/Fisher 11” DD and NEL Snake Coil
Fisher 1280-X w/8” Coil
Fisher F2 w/4”, 8” and NEL Hunter Coil
Makro Pointer
Killer B Stinger Headphones

 

[Kentucky Digger]

Sounds like you might have a small leak in the coil or the wire near the coil.
Wait a couple of days put it in a dry place see if it will dry out ...or put another coil on and see if that helps .
Gary

Thank you! I let it dry out and it works like a charm now.