pa-dirt_nc-sand
Silver Member
I went out for an hour at a very old site I pounded with the 600 in Field2, 5 tone, auto GB, horse shoe on, sensitivity 15-21, noise canceled, recovery 2 (middle settings on 600). This is my primary cellar hole set up and it worked great, over 30 flat buttons to only 8 or 9 square nails and 4-6 chunks of iron. Sort of a 2:1 ratio of target selection correct vs. fooled by iron.
Today I bumped up the recovery to 3, highest setting. (I have not messed with recovery speed since my first month with the Nox.) Hoping to uncover a few more buttons. I ended up finding targets that I could get to repeat in the low 20’s, but every one of them was a square nail. They were not perfect targets, maybe consistent number in one direction and iron or bouncy in another direction.
Should I adjust iron bias and try again? Any other advice?
Today I bumped up the recovery to 3, highest setting. (I have not messed with recovery speed since my first month with the Nox.) Hoping to uncover a few more buttons. I ended up finding targets that I could get to repeat in the low 20’s, but every one of them was a square nail. They were not perfect targets, maybe consistent number in one direction and iron or bouncy in another direction.
Should I adjust iron bias and try again? Any other advice?