Iron

mojjax · Oct 24, 2009

It's iron , has 4 points at the top ( or is that the bottom ) ?

creskol · Oct 24, 2009

I think that is a drilling point like they use on well drilling rigs. Not sure though

traderoftreasures · Oct 24, 2009

if it was a bit tip wouldn't it be carbide or tungsten? :dontknow:

FortBedfordbob · Oct 25, 2009

Might be from a Jackhammer. I used to deliver similar types of tools to job sites. The ones at least in the '70s were just hardend steel. They could be resharpened. If broken they would turn them into chisel or maul points.

thepoolguy · Oct 25, 2009

its the end for a portapower.....i would post a pick but my right click button doesnt work...can someone help?

creskol · Oct 25, 2009

thepoolguy said:
its the end for a portapower.....i would post a pick but my right click button doesnt work...can someone help?

got a website link?

thepoolguy · Oct 25, 2009

creskol if you google portapower end you will find one. i would post a site but wayyyy toooo long of an address. you might have to look at a few but you will find one with a foot like the one in question. thanks dave

creskol · Oct 25, 2009

thepoolguy said:
creskol if you google portapower end you will find one. i would post a site but wayyyy toooo long of an address. you might have to look at a few but you will find one with a foot like the one in question. thanks dave

Here is a photo .. not the best .. but it works. I think you are right!