My luck ran out.

[Back-of-the-boat]

Well It had to happen it's been too sweet, went to a park checked the tot lots then tried to change from my sniper coil to my 5x8 when I noticed one of the pins was broken off deep in the connectorwell off to Garrett it goes, I think the sniper is still under warrantyawell at least I found 81 cents before the doom and gloom.

 

Amazon Forum Fav 👍

Cry Of The Eagle: History And Legends Of The Cherokee Indians And Their Buried Treasure - Grab it through Amazon!

[Msbeepbeep]

Ooo oh nooooo!

I'd be out there with the pin pointer, being the nut that I am! Tape it to a stick.

 

[Back-of-the-boat]

Ooo oh nooooo!

I'd be out there with the pin pointer, being the nut that I am! Tape it to a stick.

I thought of that exact thing

 

[WHADIFIND]

I actually had that happen to me once. I got extremely lucky though. I stuck a needle into the hole, placed a powerful magnet on the exposed end of it and the pin pulled right out! LOL

(McGyver doesn't have ALL the tricks! LOL )

At least Garrett will run the machine thru quality control so if there are any other issues, they'll get caught and fixed at the same time.

Good luck!

 

[Back-of-the-boat]

I actually had that happen to me once. I got extremely lucky though. I stuck a needle into the hole, placed a powerful magnet on the exposed end of it and the pin pulled right out! LOL

(McGyver doesn't have ALL the tricks! LOL )

At least Garrett will run the machine thru quality control so if there are any other issues, they'll get caught and fixed at the same time.

Good luck!

That might have worked wish I hadn't already sent it off, I would have tried that. But like you say they'll do a check up on it so any bugs can be found.

 

[WHADIFIND]

That might have worked wish I hadn't already sent it off, I would have tried that. But like you say they'll do a check up on it so any bugs can be found.

More than likely it wouldn't have worked. Those holes are pretty tight. Anyway, better to have it checked.