What's new

One more question. Ace 250

Jeremy76

Full Member
Joined
Jan 16, 2013
Messages
116
Reaction score
38
Golden Thread
0
Location
Mississippi
Detector(s) used
Minelab Safari, Garrett Pro-Pointer
Primary Interest:
Metal Detecting
Ok I went out for my first time today and had a blast. However, one reoccurring problem I had was the detector would have a solid ring, strong pinpoint, dig hole, find nothing, sweep again and nothing is there. This happened on coin and jewelry setting several times. Is this normal? Finds today: 4 nails
 
Do you have a pin pointer?
 
Oops. 1 penny, 1 quarter, 1 cola pull tab and 1 brass off of a shotgun shell. I'm on my way to being a detector legend.
 
AdDicted2Ag said:
Do you have a pin pointer?

No I don't. That's next though.
 
That should be top priority..
 
That should be top priority..

next time go in all metal and see if that helps...the hallo around the target was broke when you dug the hole and now your distcrimination is kicking in and preventing it to belltone....
 
AdDicted2Ag said:
That should be top priority..

Pointer ordered. All advice appreciated.
 
I had that happen with my AT PRO had a hit as though it was a dime so I dug and i have a pointer. I used my pointer and at first got a signal then it diappeared. I scanned and scanned again with both pointer and detector and nothing there. I even went out 2' beyong my hole knowing that sometime when you dig the coin falls out of your plug and you think you lost it but the pro pointer had always found it a few inches from the plug except for the one time when i found nothing
 
i have a 250 as well. I have experienced the same thing as you. Most of the time its been a tiny bit of tinfoil or the coin fell out of the plug. But on occassions I get this as well. I know overhead electric lines cause my 250 to lose its mind. \
 
ammo_u said:
i have a 250 as well. I have experienced the same thing as you. Most of the time its been a tiny bit of tinfoil or the coin fell out of the plug. But on occassions I get this as well. I know overhead electric lines cause my 250 to lose its mind. \

That's a good point. Now that I think about it there were power lines near the area I was searching. I'm new and learning as I go.
 

Users who are viewing this thread

Back
Top Bottom