Safari

[Hardtack1862]

The word from the factory is follow what the owners manual shows and that is to Noise Cancel with the loop a foot off the ground. Because EMI is in the air not in the ground. Noise Cancel should be done more than once during a detecting session.

 

[Ray in CA]

That was my impression too. I read Andy's book, which says to noise cancel on the ground. But his book is mainly a Quattro book, not a Safari book (although almost everything about the Quattro will apply to the Safari). The Minelab manual, however, says to noise cancel around 12" from the ground, which is what I have been doing since having read it. Seems to be working for me, although I can't say that when I did noise cancel on the ground there was any difference.

Ray

 

[Dale Simmons]

I 've tried both ways. I can't really tell the difference. I usually just do it on the ground now.

 

[Dale Simmons]

I've tried both ways. I don't see a difference in the machine with either way. I usually just lay it on the ground now.

 

[mpostma]

Same here, I just set the coil on the ground when I noise cancel too.
I am using a Quattro.
Good Luck,
Mark