Shaft Q (rubber bushings)

3RINGER · Nov 27, 2014

In all the detectors I've had the lower shaft has had two rubber bushings where the coil is connected. On the 3D I got It only has one bushing...should there be a second on the other side??

If so where is the best place to get bushings from?

thx for any help

Pointman · Nov 27, 2014

I have a CZ coming in this week and I can better tell. If it needs a rubber bushing, I probably will have a few laying around that will work with all the lower rods I have collected from other detectors. I will let you know if it needs one and if I have any that may do it.

3RINGER · Nov 28, 2014

Thx pointman, up early for a cup of coffee and read time before heading out to a CW site. Thx again for the reply.

Hookedondetecting · Nov 28, 2014

I have two black ones on the coils for my F75.
I sent the coils in for the upgrade.
When the unit came back my two rods and the same two black bushings.
The new instruction book came in a plastic bag with only two bushings that are red. One for each coil.
So I think the one for each is all they provide now.

Pointman · Dec 2, 2014

3RINGER said:
In all the detectors I've had the lower shaft has had two rubber bushings where the coil is connected. On the 3D I got It only has one bushing...should there be a second on the other side??

If so where is the best place to get bushings from?

thx for any help

I just received my CZ today and yes there are two rubber washers on each side. There are two recesses in the lower rod on each side for them. PM me your address and I will send you two rubber washers that I have found laying around that will work for you. I don't need you to pay me.