danec71
Full Member
- Joined
- Oct 14, 2014
- Messages
- 135
- Reaction score
- 151
- Golden Thread
- 0
- Location
- washington
- Detector(s) used
- At gold
- Primary Interest:
- All Treasure Hunting
Looking for some info since my motor is stuck up in the woods and I don't have the pump with me. I have to get a new motor and I bought one that I'm going to take him to my friends machine shop and have him thread the shaft real quick which I've done before with a smaller pump. So it's an older Keen 350 pump.it's the older 5 inch Dredge where they bolted the yellow pontoons to the frame single crash box type sluice box. I called Keith and he told me 1-14 unf2 right hand. Took him a while to look it up and he seemed somewhat sure. Obviously they should know and I trust him but I just want to doublecheck because one side thread the shaft of thats it. I know going and getting the pump that would be the best deal but I don't know that I can make it and I want to take this new engine up there with me. If all else fails and nobody is really sure I'll just go and sacrifice a day to get the motor and pump. But if anybody can help that would be awesome. Threading and shaft size andentry if possible
Upvote
0
