4ft Chicago Press Break for sale.

[Mine Shaft]

Hi everyone i was in business for 30 years as a precision sheet metal mechanic. After going out of business in 2007 i worked out of my garage for a while. So i am looking to sell my 4ft Chicago 15 ton Mechanical press break. I am asking $2,000.00 firm that includes all my pressbreak tooling 100s of dies and a lot of custom made tooling + you will get 1 Roper Whitney hand punch with all tooling for punching holes from .062 - 1" plus 100s of different punch dies + 1 Roper Whitney 6" corner hand notcher. This press break needs a little cleaning but it runs very well and will bend parts day in day out. The break weighs approximately 2100lbs and will need to be remover by a machinery mover "Local pick up only" Thank you regards Craig.

 

Amazon Forum Fav 👍

Upgraded Night Vision Monocular Digital Infrared Monocular Telescope for 100% Darkness with 8X Zoom - Grab it through Amazon!

[Blackfoot58]

D&Ks were true workhorses.
What voltage is it set up for?
I can’t see the main disconnect.
I’d guess 220 VAC since you had it at home, unless you are in an area zoned for industrial with 480 3 phase. Thanks.

 

[Mine Shaft]

D&Ks were true workhorses.
What voltage is it set up for?
I can’t see the main disconnect.
I’d guess 220 VAC since you had it at home, unless you are in an area zoned for industrial with 480 3 phase. Thanks.

Hi Blackfoot! yes its 220.

 

[Blackfoot58]

I know a friend who may be interested. I’ll let him him know. Will post any questions he may have.

 

[Mine Shaft]

I know a friend who may be interested. I’ll let him him know. Will post any questions he may have.

Sounds good defiantly let him know. Thank you regards Craig.