Coil Change Question

P47RCFlyer

Jr. Member
Jan 16, 2013
95
77
White Oak, Texas
Detector(s) used
Garrett "Ace 250", Garrett "Groundhog", BH "Tracker IV", Garrett Pin Pointer
Primary Interest:
All Treasure Hunting
yup....but you may have to make a couple adjustments on pinpointing and id.....worth it tho
 

yup....but you may have to make a couple adjustments on pinpointing and id.....worth it tho

I'm not sure what that would require. I'm not up on modifying things like that. Is it difficult to do or should i take it somewhere to have it done?
 

P47RCFlyer ,

I own a White's GMT that came with the stock 8 x 10 DD coil and I purchsed the 4 x 6 DD coil. I also own an XLT with an assortment of coils including the 4 x 8 DD for it.

In both cases the 4 x 8's search pattern tightens up the search pattern and I've found good targets with it. The 4 x 8 being a small coil physically fits in smaller places and due to its smaller size has an easier time locating good finds between trash targets, the type of search pattern from the DD coil as well as its small size all add to its ability to find good in among bad targets.

I am pleased with my DD coils and of course they are made for the frequency of my machines so as long as the coil is made for your machine then it will be a positive addition to your metal detecting experience. Understand that due to its small size it forces you to go slower and that is what people say all the time anyway so it is not a bad attribute.

I would purchase it if it were for my machine! Hope this helps....................63bkpkr
 

Thanks for the info. Kellyco has a Garrett 5x8dd that is made for the ACE series. Since it is made for the ACE would i still have to adjust it as "bigfoot1" mentioned above?
 

As long as it is made for the Ace series then it should have the proper kHz factor built into it and pinpointing and ID's should be the same.

I've not noticed any differences with either of my machines using any of the coils that are made for them as compared to the stock coil that came with the machine. Hey, better yet, confirm this with the folks that make your detector!!..................63bkpkr
 

Top Member Reactions

Users who are viewing this thread

Back
Top