Inexpensive crevicing tool

[gravelMaster]

Was searching for a lightweight, sturdy and quality tool that would not break the bank. Made out of stainless

steel and costs is about $17.00 and weights under 1 pound. Search amazon.com for Lanyota. I do not sell this item or have any interest in it, other than letting people know that there exists a great tool to be found.

 

[russau]

I always made my own tools ! I didn't have the bucks to spend on store bought tools ! I made my pick from a old car leaf spring and welded a steel pipe coupling to it to screw the pipe handle on it ! I had the parts in my junk pile ! Cost ? a little of my time ! matter of fact I made lots of tools and give them to our club member for FREE back then !

 

[gravelMaster]

I always made my own tools ! I didn't have the bucks to spend on store bought tools ! I made my pick from a old car leaf spring and welded a steel pipe coupling to it to screw the pipe handle on it ! I had the parts in my junk pile ! Cost ? a little of my time ! matter of fact I made lots of tools and give them to our club member for FREE back then !

I used to make most of my tools also... but at $17 and under a pound and stainless steel to boot.

 

[russau]

Good for you ! But for me at 78 years old and lots of time to spend out in my shop anyway , I'd prefer not to spend the $$ when I can make it from what I already have.