Keene RC46 testimonials

[Load77]

Curious if anyone had first hand experience with these crushers?
Actual output, average mesh with one pass, etc?

Thanks!

 

[Mad Machinist]

I honestly think the Keene RC46 is way overpriced for what it is but there are few options out there. From what inhave seen, it works great in some ores but not so good in others. Your average mesh is going to depend upon how much wear is on the machine.

 

[russau]

If the crush plate's aren't welded with hard face rod's to improve it's durability buy a couple of pounds of hard facing rods (if you have access to a welder) and weld a cross hatch pattern on them !