My Excalibur coil falsing problem is fixed

[relicpro]

I had replaced the plastic coil bolt on my Excal with a brass one so that I could tighten it better. Every time I bumped my coil it would false. Went back to the plastic bolt and NO MORE PROBLEMS!!

 

[Narthoniel]

If you need replacement bolts, check at Lowes or Home Depot for Nylon Bolts. They were in a drawer in the nuts and bolts section when I checked. I recommend checking for those first, if they arent there, I heard toilet seat bolts work as well, but they are too wide, and you have to ream out the holes on the coil. I didn't like that idea, and hunted for a better alternative, and there it is.

Hope this helps.
Anthony

 

[relicpro]

THANKS ANTHONY

I will pick a couple of extras up at Lowe's

 

[Sandman]

Using a metal bolt is not a good idea as it distorts the field. Why do you think the factory uses Nylon bolts and nuts?

 

[Ray S ECenFL]

 

[TheSleeper]

Any metal near the coil will give you falsing, be that a mounting bolt "OR" even the coil wire wrapped around the stem close to the coil.
Always use a plastic bolt and never wrap the coil wire around the stem withen 8" of the coil. I always run the coil wire straight along the stem with wire ties til it is atleast a foot above the coil before wrapping it around the stem.