Ace 250 not reading coins

[SilverDreams]

I went out yesterday evening with my Ace 250 and I was getting crazy readings all throughout my yard. When I registered a good coin signal, I couldn't find anything. I just assumed I was getting a lot of interference so I went back out this morning. I wasn't getting many false readings, but when I would throw down a quarter to test out, my detector will not pick it up, no matter what I try. I have put all new batteries in, checked my coil, all my connections are good. Can anyone help?

 

[Dihren]

Is it on the right mode?

 

[SilverDreams]

Yes, I have it in coin mode and I don't have any coins discriminated out.

 

[inspectorgadget]

Ground balance sounds way off or else your machine needs to take a trip back to Garrett for a fix.

 

[Sandman]

Ground balance sounds way off or else your machine needs to take a trip back to Garrett for a fix.

Best to send it back....

 

[mccloud39]

Put your sensitivity at 4 and see if that helps and do some bench testing

 

[Ace350]

You're best bet is to call Garrett.
Their customer service is second to none.
They will help you resolve your problem.

 

[dholland02]

I run my ace250 with only 2 bars from the bottom of the scale

 

[ecmjamsit]

Press "PWR" button down and hold it til you hear two beeps. This resets the machine! Then adjust sensitivity and discriminate. I usually go with sensitivity at 3 bars.

 

[coryide123]

you need to send it back>>>> mine dose not do that!!!!

 

[TerryC]

Do the hard reset first, as mentioned above. When you call, they will ask you to do that first anyway. TTC