Ace 350 Pulsating Pinpoint?

[CyberWoolf]

I was at my friends house last night and we were MD her yard. I had the strangest thing happen when I went to pinpoint an object with the 350. When I hovered over whatever it was, the bars kept pulsating. I would go from 0 to full bar then back to 0 then full bar. I have never had that happen before! Anyone else have this happen? Was the item too deep or something?

 

[Kodiak43351]

Very small target is my thought.

 

[CyberWoolf]

I'll have to check it out again next time I'm over there and turn my sensitivity up. Thanks!

 

[RobRieman]

You didn't dig it up to see what it was

 

[rks1949]

I'll have to check it out again next time I'm over there and turn my sensitivity up. Thanks!

Always try to run your sensitivity as high as you can. It steps the machines performance up to max!

 

[marh415]

Make sure it's actually a target and not an electrical wire or something, it's happened to me before in my yard.

 

[CyberWoolf]

Make sure it's actually a target and not an electrical wire or something, it's happened to me before in my yard.

That's why I didn't dig it up :-D It was 8+, so I thought would ask around before I started to dig!

I had my sensitive down because I was in an area before that with a lot of junk metal.

Now I'm curious! Thanks for all the responses.