What's new

At pro question??

relic nut

Silver Member
Joined
Nov 29, 2014
Messages
4,006
Reaction score
7,277
Golden Thread
1
Location
VA
🥇 Banner finds
1
Detector(s) used
Minelab CTX 3030 TELEKINETICS 4000 GARRET AT PRO
Primary Interest:
All Treasure Hunting
When I first turn on my detecter and ground balance, seems like it is a little erratic for about 5 minutes or so. Do they need to warm up or am I just nuts?
 
When I first turn on my detecter and ground balance, seems like it is a little erratic for about 5 minutes or so. Do they need to warm up or am I just nuts?

Ehh Maybe a little!! :laughing7:

I have an AT an never noticed this happening
 
It's probably more the process of your brain getting used to the sounds again. It takes a few minutes to start mentally filtering out the chatter and focus on the sweet sounds of good targets.
 
Things to check that everyone seems to miss with the ATP.

1. Make sure that coil to Head unit cable is wrapped SNUG & The end fitting is ALL the way in, its a little tight but makes a triumphant difference

2. Make sure when you GB you raise and lower around 7-9" and and the lowest downward stroke should be 1" from the soil/ground and that's where you would swing from.

3. If you are near any electrical boxes, move away, it has a huge disturbance with these machines. I was 25' away from one once and it was just going Bat $hit crazy, got 40' away and it completely stopped.

Good luck!
 

Users who are viewing this thread

Back
Top Bottom