What's new

Big Item Question

gods country girl

Full Member
Joined
May 18, 2007
Messages
213
Reaction score
12
Golden Thread
0
Detector(s) used
whites mxt
Primary Interest:
All Treasure Hunting
i have detecting in relic mode, and i have found some misc hunks of metal and nails yet to be cleaned up and identified.my question is i keep getting a big item signal and i have dug 12" down and its still showing big item how far should i go?
 
Upvote 0
stop at 125 Feet

You don't wanna hit water

Seriously Though, I quit when I Decide I Dug far enough

I Know that Nickel signal is here yet
mirmineAP130307_468x361.webp
 
Try probing out instead of deeper, I dug about 2 feet down right thru the center of an old metal barrel strap that was only about 4 inches deep. Wasted a couple of hours trying to find my target lol. good luck,

HH Charlie
 
ty will try the probe
 
Your decision depends on what type of site your on. For me, I dig until I get to the target which is usally not much more than two feet, and seldom in the range of 3 feet, but if it's deeper I keep going.
 
jeff of pa said:
stop at 125 Feet

You don't wanna hit water

Seriously Though, I quit when I Decide I Dug far enough

I Know that Nickel signal is here yet

I bet its one of those pesky little silver 3 centers :thumbsup:

;D ;D ;D
 
Could be a safe full of money from the Austin flood. Keep digging til you find it, and keep quiet when you suddenly become rich!!
 
went 18" down still said big item.from the display, it shows whatever it is ,is about 2 foot across.i covered it back up loosely, i think i will try to dig it some more on my next days off.
 

Users who are viewing this thread

Latest Discussions

Back
Top Bottom