Digger2
Bronze Member
- Apr 9, 2013
- 1,099
- 204
- Detector(s) used
-
XP DEUS,Garrett AT Pro, GTI 2500 ,
Minelab Explorer II
Garrett pointer
Garrett Pro Pointer
Detectorpro Uniprobe
Vibra-tector 730
Vibra-Probe 580
- Primary Interest:
- Metal Detecting
The coil does not charge, polarity is in the direction shown in manual (connector on shaft side)......LED does not light up.
After a 3 hour charge on everything (with no led on coil to show it was charging)... remote shows.....no coil. I tried again switching the lead in wire (I used a different one). LED does not light, so the coil is not charging. (Manual says it takes 10 seconds or so to come on....It didn't come on after 5 minutes)
Any suggestions.
After a 3 hour charge on everything (with no led on coil to show it was charging)... remote shows.....no coil. I tried again switching the lead in wire (I used a different one). LED does not light, so the coil is not charging. (Manual says it takes 10 seconds or so to come on....It didn't come on after 5 minutes)
Any suggestions.