rks1949
Hero Member
- Joined
- May 13, 2013
- Messages
- 949
- Reaction score
- 380
- Golden Thread
- 0
- Location
- Lawrenceville,Il.
- Detector(s) used
- XP Deus, Garrett AT Max, Nokta Simplex +, Nokta Legend ,Garrett Pro Pointer , Fisher F Point, Garrett Digging Tool, Gator Razor, Digging Tool, Sampson Digger, Get the Track Hoe! It's a deep one! :)
- Primary Interest:
- Metal Detecting
- #1
Thread Owner
Well I finally did it yesterday!
I pulled my garrett digger out of it's sheath a little sideways,and ripped the side of the sheath open!
It has always fit a little tight,and when it gets dirty,it sometimes is hard to pull out of the sheath with one hand. So a little Red Neck modification was in order!
I cut the other side down to match the one I tore,then cut across to the other side. I made a bracket out of white oak ( I have some laying around the shop) and used gorilla glue to attach it to the sheath. Then I used some small rubber tubing to go along the top edge of the bottom section. It now works better than it ever did!
I can easily draw it out or put it back in with one hand,and it's easier to shake the dirt out of it after a hunt!
I pulled my garrett digger out of it's sheath a little sideways,and ripped the side of the sheath open! It has always fit a little tight,and when it gets dirty,it sometimes is hard to pull out of the sheath with one hand. So a little Red Neck modification was in order! I cut the other side down to match the one I tore,then cut across to the other side. I made a bracket out of white oak ( I have some laying around the shop) and used gorilla glue to attach it to the sheath. Then I used some small rubber tubing to go along the top edge of the bottom section. It now works better than it ever did! I can easily draw it out or put it back in with one hand,and it's easier to shake the dirt out of it after a hunt!
