need help please v3i

[nscrcr8z]

Hello friends...ill try to explain. This best I can I've got my v3 few months back and when. I got it I loved it ...got thru the learning curve ... I thought. Its getting here lately where I'm not finding #$$#!! What I'm finding its doing a lot is say for instance. When I'm going over a target say reading dime/ penny go to pin point it reads pulltabs / foil..is it annylizing target and adjustinit also has a small delay to the signal ...is there. A master reset for. This. Machine..? Am I doing something. Wrong?
Or is it just way above. My intellectual experience. Loll
I hope I detailed. It enough to where its understood...tyre for your input ...by the way I have. An xl. Pro 6000 which. I'm finding I'm using a lot more lately ...to make this. Hobbies more relaxing again

 

Amazon Forum Fav 👍

Agony and Death on a Gold Rush Steamer: The Disastrous Sinking of the Side-Wheeler Yankee Blade - Grab it through Amazon!

[Lost2Much]

Make sure the loop Selection- under Configure- is set correct. If that doesn't solve it --give it back to dealer. I did. Whites said a wire was loose in the coil. MXT is still my primary machine.

 

[minton7]

I got my V3i just outta the box and started hunting... didnt even read the book yet... did very well with it even so