Hunt4gold
Full Member
- Joined
- Oct 20, 2016
- Messages
- 215
- Reaction score
- 559
- Golden Thread
- 0
- Location
- Colorado, Littleton
- Primary Interest:
- Prospecting
Wanting to get some insight on how to process my +20 classified material... Have learned a ton from people on this site (just started prospecting in October) so I am confident that good advice on this topic. If I can set up my Bazooka on a stream/river, then I just run all my material through it, but sometimes there is not enough flow (and no way to build a dam) to set it up. So then I begin by running material through a #8 classifier, and then a #20, and on occasion I will then put it through a #50 and then pan out the remaining -20 or -50 material. My question is what is a good method to process the leftover +20 material. Maybe I am being overly optimistic, but I hope that someday there will be a +20 nugget or flake in there! Have gotten decent in panning out the -20, but panning the +20 seemed difficult. I also tried running it through my Miller table - cranked up the slope to 6-7 degrees and increased the water flow. Seemed to work Ok, just have to move along some of the flatter pieces. Any help/suggestions appreciated.
Amazon Forum Fav 👍
Upvote
0