Never tried this-I would just knap a new one... But here is an idea- Most points are pretty symetrical. Push the point into some type of clay that has been flattened on both sides, so it is to the center line depth. (centerline being halfway between the front and back) remove the head and flip it from front (F) to back (B)and push it back into the same piece of clay and remove. This half should look complete. Fill it with epoxy or resin and use a plastic putty knife to scrape of the excess level with the clay. Now repeat the process with the head starting on side B and flipping to side F. Once the two are dried used a super thin amount of the same resin or epoxy and glue the two pieces together. Again, I never tried it but you would have a good idea of what the head may of looked like and no one in their right mind would mistake it for a true artifact.. well lets hope so. Also you could paint it!!!!