CoilToTheSoil
Hero Member
- Mar 14, 2015
- 700
- 914
- Detector(s) used
-
XP Deus
Minelab Sovereign xs2a Pro
Minelab Sovereign GT
Minelab X-Terra 705
Minelab Explorer SE
Minelab e-trac
Tesoro compadre
Whites v3i
AT Pro
Teknetics Gamma 6000
Bounty Hunter Camo LS
Bounty Hunt
- Primary Interest:
- All Treasure Hunting
Started off slow then in the last 30 minutes pulled 2 buttons and a nice 1861 seated dime with great detail. I can't find any info on the smaller button. Says Morling Balt. On it and has patterns front and back. The larger coat button has a faint line design on it.
Very pleased with the hour and a half I went out in the rain today. But MAN is that site filled with iron and square nails. Worth it but it's slow goin. The 2 buttons came out of the same hole along with 5 or 6 small square nails. The dime was mere feet away and the confederate droop wing button I found last week was found 10 ft from where these were.
Anyone have any info on the morling balt?
Very pleased with the hour and a half I went out in the rain today. But MAN is that site filled with iron and square nails. Worth it but it's slow goin. The 2 buttons came out of the same hole along with 5 or 6 small square nails. The dime was mere feet away and the confederate droop wing button I found last week was found 10 ft from where these were.
Anyone have any info on the morling balt?
Amazon Forum Fav 👍
Last edited:
Upvote
14
You sure are successful pulling good target out of that iron infested site.
