What's new

XS in tot lots

minelab rick

Full Member
Joined
Jul 1, 2006
Messages
161
Reaction score
1
Golden Thread
0
Location
Charlottesville, Va
Detector(s) used
Minelab Explorer XS
I have a xs and hunt with it almost every day. During my lunch hour I go to a close by school or park and get in about 40 minutes of hunting. My problem is tot lots. I can't get any closer than about 8 inches of the metal poles. I've tried low sensitivity and high sensitivity. Is there a setting that will allow me to get closer to the play eqipment? Or is there something that I could carry to block the poles? Any suggestions would be appreciated. I know I'm missing some good targets.
Thanks
Rick
 
I think its very hard to do much, but you can try, switch to ferrous without discrimination--open screen-- drop sensitivity and listen. in some situation even if you hear ferrous everywhere you can hit target by sound too,,very mix target ID,,. sometimes when I hunt on old houses site I have similar situation and sometimes I dig something. good luck
 
A smaller coil, and maybe a concentric would have less of an outside foot print. But personally I would just avoid getting too close, and there's still 99.9999% of the area to hunt!
 
Iron Patch said:
A smaller coil, and maybe a concentric would have less of an outside foot print. But personally I would just avoid getting too close, and there's still 99.9999% of the area to hunt!

Aside from using a smaller coil there isn't much you can do. Remember the metal poles sometimes go in the ground at an angle too.
 

Users who are viewing this thread

Back
Top Bottom