I lost my rolex in a river

[Gwozhog]

Okay im not a metal detector hobyist by any means. Just an idiot who decided to go wakeboarding with an 8k watch on my wrist. The watch flew off my wrist in a nasty reverse faceplant. I have an area to search that is about 50 yards by 30 yards. The river water is about 7ft deep with zero visibility. Im looking at purchasing the tesoro sand shark detector and was wandering if there is a cheeper underwater detector that will get a one time search and rescue job done. The watch is all Stainless steel. Any help would be appreciated.

 

Amazon Forum Fav 👍

Treasure of Victoria Peak - Grab it through Amazon!

[bigfoot1]

I highly recomend you go to,"theringfinders.com"and contact the recovery guy in your area right away.most of us work on a reward only basis and it is the expierience that makes the find...not just the machine.Time is critical...call right away and best of luck to you

 

[Shunkaha]

If it's stainless steel, then I would get a good magnet bar and start running it over the area. Or just make something like this: WONDERMAGNET.COM - NdFeB Magnets, Magnet Wire, Books, Weird Science, Needful Things

 

[DonDigger]

A recovery Magnet will probably not pick up a Rolex due to its non-magnetic stainless steel alloy. To verify my memory that some stainless is non-magnetic I did the following searches:

From a Google search: Stainless steels are iron-based alloys primarily known for their generally excellent corrosion resistance, which is largely due to the steel's chromium concentration. There are several different types of stainless steels. The two main types are austenitic and ferritic, each of which exhibits a different atomic arrangement. Due to this difference, ferritic stainless steels are generally magnetic while austenitic stainless steels usually are not.

From Rolex's site: Rolex uses 904L stainless steel which is commonly used in high-technology and in the aerospace and chemical industries. Its excellent anti-corrosion properties, comparable to those of precious metals, are due to its high chrome content.

From a Google search: 904L is an Austenitic Nonstandard grade Stainless Steel. It is composed of (in weight percentage) 0.02% Carbon (C), 2.00% Manganese (Mn), 1.00% Silicon (Si), 19.0-23.0% Chromium (Cr), 23.0-28.0% Nickel (Ni), 0.045% Phosphorus (P), 0.035% Sulfur (S), 4.0-5.0% Molybdenum (Mo), 1.0-2.0% Copper (Cu), and the base metal Iron (Fe). Other designations of 904L stainless steel include UNS N08904 and ASTM B625.

 

[Shunkaha]

A recovery Magnet will probably not pick up a Rolex due to its non-magnetic stainless steel alloy. To verify my memory that some stainless is non-magnetic I did the following searches:

From a Google search: Stainless steels are iron-based alloys primarily known for their generally excellent corrosion resistance, which is largely due to the steel's chromium concentration. There are several different types of stainless steels. The two main types are austenitic and ferritic, each of which exhibits a different atomic arrangement. Due to this difference, ferritic stainless steels are generally magnetic while austenitic stainless steels usually are not.

From Rolex's site: Rolex uses 904L stainless steel which is commonly used in high-technology and in the aerospace and chemical industries. Its excellent anti-corrosion properties, comparable to those of precious metals, are due to its high chrome content.

From a Google search: 904L is an Austenitic Nonstandard grade Stainless Steel. It is composed of (in weight percentage) 0.02% Carbon (C), 2.00% Manganese (Mn), 1.00% Silicon (Si), 19.0-23.0% Chromium (Cr), 23.0-28.0% Nickel (Ni), 0.045% Phosphorus (P), 0.035% Sulfur (S), 4.0-5.0% Molybdenum (Mo), 1.0-2.0% Copper (Cu), and the base metal Iron (Fe). Other designations of 904L stainless steel include UNS N08904 and ASTM B625.

Well bummer. Thanks for the info.

 

[signal]

If its not a saltwater river then a Tiger Shark may work better, I am not sure, the Tesoro people will likely chime in.

7ft can be challenging, and 0 visibility can be challenging too. Don't give up, its doable and you'll probably find it quicker than you think

 

[gunlocators]

And if the river has any high currents you may push your search are radius further even heavy items can travel down river I would get someone to help ASAP

 

[BVI Hunter]

Don't feel too bad.......

Ever lost a Rolex? - Rolex Forums - Rolex Watch Forum

hope you find it!!

 

[huntsman53]

Post a Thread in the "Metal Detecting" forum or go to "TreasureNet by Location", find your State and post a Thread in the appropriate forum for help.


Frank

 

[Metal Detecting Stuff]

The Sand Shark has no discrimination, so it will pick up every nail and bobby pin. Are you dive certified? 7 feet of water is difficult to metal detect.

Wayne

www.metaldetectingstuff.com

 

[Hot zone]

A magnet could still help by removing many unwanted signals...add Tiger shark and Breathing apparatus etc... If you don't find it you may have found a new hobbie too spend a few K on...

 

[fella]

If it's not salt water, the detectors that come to mind are the Fisher 1280x, Garrett AT Pro, Whites Beach Hunter ID 300 & Tesoro's Tiger Shark. the AT Pro is the cheapest of the lot but the head phones that come with the AT Pro are NOT submersible so that would be an extra cost.

If it is salt water, the Whites Beach Hunter ID 300 will still work well, Fisher CZ21 or Minlab Excalibur. The Fisher will be pretty pricey and the Minlab even more so if you're just looking for a one time use. Still, either should resale fairly well if it's still like new.

Or... you could hire someone with a detector & experience to find it for you!

 

[Iron Patch]

If it's not salt water, the detectors that come to mind are the Fisher 1280x, Garrett AT Pro, Whites Beach Hunter ID 300 & Tesoro's Tiger Shark. the AT Pro is the cheapest of the lot but the head phones that come with the AT Pro are NOT submersible so that would be an extra cost.

If it is salt water, the Whites Beach Hunter ID 300 will still work well, Fisher CZ21 or Minlab Excalibur. The Fisher will be pretty pricey and the Minlab even more so if you're just looking for a one time use. Still, either should resale fairly well if it's still like new.

Or... you could hire someone with a detector & experience to find it for you!

Even if it's salt water we're talking about a one time thing to find a fairly large target, so a VLF would probably be the better tool because it would be a heck of a job digging everything at 7 feet with a pulse. The salt wouldn't matter much because even on low sense you'll get the watch... the key would be to make sure to set the disc where it would accept it. I'd probably buy an AT Pro because it will likely have the best resale value.

 

[Rodbuster209]

Being a avid water hunter and having owned a Rolex buy a used water machine and find it yourself then sell the machine, try that first,before telling a stranger where you lost a 8k watch, was it a Submariner?

 

[Jason in Enid]

If its not a saltwater river then a Tiger Shark may work better, I am not sure, the Tesoro people will likely chime in.

7ft can be challenging, and 0 visibility can be challenging too. Don't give up, its doable and you'll probably find it quicker than you think

HA! You're in for a challenge! 7 feet deep.... too deep to wade and you have zero vis. You will have to get your coil directly over it and you have a LOT of square inches for it to be hiding in. I once dropped a bright orange camera in 4 feet of river with about 2 foot of vis. It took me half an hour to find it with a visual search, and I knew within a few feet of where it fell.

 

[bigfoot1]

well I hope ya all noticed that op is long gone.We all gave him good advice and hope the best for him but to post to him directly is kinda wierd.If he contacted the site I hoped he would....bam....a pro with the right equipment and expierience will be on the scene already.

I only mention this because I shudder to think that a guy who freely claims he has no clue is told what machine HE needs to hunt the deep channel of a river 7 feet deep.No visibility.

Lets just recommend that he drain the river....same chance of success.Guys and gals...is anyone here really that willing to send a no nothing fellow into a dangerous scene like that?

Let the pros do it....pros like you all....that is what say I...what say you?

 

[Jason in Enid]

I highly recomend you go to,"theringfinders.com"and contact the recovery guy in your area right away.most of us work on a reward only basis and it is the expierience that makes the find...not just the machine.Time is critical...call right away and best of luck to you

Or contact "lostmystuff.net" They don't charge for recoveries.

 

[Jason in Enid]

well I hope ya all noticed that op is long gone.

WTH are you talking about? Long gone? It wasn't even 24 hours ago that he posted.

 

[bigfoot1]

oops double posted....I should let the pro typists do this....lol

 

[fella]

Even if it's salt water we're talking about a one time thing to find a fairly large target, so a VLF would probably be the better tool because it would be a heck of a job digging everything at 7 feet with a pulse. The salt wouldn't matter much because even on low sense you'll get the watch... the key would be to make sure to set the disc where it would accept it. I'd probably buy an AT Pro because it will likely have the best resale value.

All the ones I mentioned ARE VLF's! But I agree with the ATP choice, but guy is still gunna need a different headset.