coinman123
Silver Member
- #1
Thread Owner
I had some free time at 3pm to around 5pm and turned the vintage axe head I found into something pretty cool.
Anyways, The axe head is not very old, maybe 1930's or 1940's. It is a commercially made axe head with the words, "Red Knight stamped on it. I saw a fleck of red paint the very top too. Any help IDing it would be cool.
Well, I decided to clean it up and put it in my "iron pile" in my shed until I had an idea. Why not clean it up, leave a nice dark patina, and put a new handle and put it on my wall?? For the first hour I was cleaning the opening where the handle would go, some old wood chips from the original handle were left in there. I noticed that there were long iron spikes for the handle to go in. Next I went into my yard and looked for the perfect "handle" I found a nice stick and snapped it to the right size. Than I fixed up the ends to be flat. I chipped it to the right width with a screw diver and Swiss-Army-Knife. Then I grabbed my sledge hammer and hammered the branch in, making sure that it nailed into the big spikes. I then grabbed some little woods chips and hammered them in the right of the opening for the handle. The handle was in there so firm that it did not wiggle the slightest bit.
What do you think?? I turned what used to be a common axe head from my finds pile to something that can be displayed on a wall as a piece of art.

Anyways, The axe head is not very old, maybe 1930's or 1940's. It is a commercially made axe head with the words, "Red Knight stamped on it. I saw a fleck of red paint the very top too. Any help IDing it would be cool.
Well, I decided to clean it up and put it in my "iron pile" in my shed until I had an idea. Why not clean it up, leave a nice dark patina, and put a new handle and put it on my wall?? For the first hour I was cleaning the opening where the handle would go, some old wood chips from the original handle were left in there. I noticed that there were long iron spikes for the handle to go in. Next I went into my yard and looked for the perfect "handle" I found a nice stick and snapped it to the right size. Than I fixed up the ends to be flat. I chipped it to the right width with a screw diver and Swiss-Army-Knife. Then I grabbed my sledge hammer and hammered the branch in, making sure that it nailed into the big spikes. I then grabbed some little woods chips and hammered them in the right of the opening for the handle. The handle was in there so firm that it did not wiggle the slightest bit.
What do you think?? I turned what used to be a common axe head from my finds pile to something that can be displayed on a wall as a piece of art.









