What's new

Tiny Sheetmetal screw

k0bgalan

Sr. Member
🥇 Charter Member
Joined
Jun 1, 2026
Messages
263
Reaction score
812
Golden Thread
0
Location
Roswell, NM
Detector(s) used
All Garrett: Ace 250 (two), AceApex, VX-9. Have owned just about every Garrett ever made. First three detecter I made myself, with the first one in 1962.
This little screw is about 3/8 long, and was found with my VX-9 on FAST mode. The plug was about 6 inches long, and this was stuck to the very bottom of the plug. That is no big deal, but the fact it measured a 92 certainly is! Why it measured that high is a mystery to me.
 

Attachments

  • Screw.webp
    Screw.webp
    17.6 KB · Views: 8
Upvote 1
This little screw is about 3/8 long, and was found with my VX-9 on FAST mode. The plug was about 6 inches long, and this was stuck to the very bottom of the plug. That is no big deal, but the fact it measured a 92 certainly is! Why it measured that high is a mystery to me.
I swear its the jagged edges and points on rusty nails and screws. You induce a minute voltage the point amplifies the return signal. Back EMF of some sort.
 
Nearly all the old small iron I encounter comes up as a mid to high tone, but its usually very unstable jumping between numbers. I dig them anyway just in case there is signal masking something valuable nearby. Found a silver in the same hole as an iron nail a few days ago with that same unstable signal in an area completely choked full of jumpy mid-high tones that otherwise were all small rusty iron. I feel many would have passed it over.
 

Users who are viewing this thread

Back
Top Bottom